Thermo Controller Digital for Cooling or Heating 1000w

Thermo Controller Digital for Cooling or Heating 1000w

  • $109.00



Thermo Controller Digital for Cooling or Heating 1000w 

  1. Heating function: When work with a heating element such as a heater, you will need to first set the working mode to be heating control (a small sun mark will show on the screen, press and hold “set” button to change the heating & chilling control), then set the target temperature. The controller will automatically monitor the actual temperature and control the output to the heating element. When the actual temperature reaches 1C or 1F above target, the output will stop. Then when the actual temperature reaches 1C or 1F below target, output will be active again.
  2. Chilling function When work with a chilling element such as a chiller, you will need to first set the working mode to be chilling control (a small snow mark will show on the screen, press and hold “set” button to change the heating & chilling control), then set the target temperature. The controller will automatically monitor the actual temperature and control the output to the chilling element. When the actual temperature reaches 1C or 1F below target, the output will stop. Then when the actual temperature reaches 1C or 1F above target, output will be active again.

INDICATING LIGHTS

  1. Power buttonWhen the input power plug is properly plugged into a socket, the power button will on.
  2. Output buttonWhen the controller is outputting power to the output connector, this button will on; when the power output stops, this light will off.

SETTING BUTTONS

  1. Set:Press this button once, the display mode will switch between F and C. Make sure you are using the familiar display mode to avoid any mistakes. The screen will flash for 3 seconds and then back to normal working mode.
    Press this button and hold for 3 seconds, the controlling mode will switch between heating and chilling. The screen will flash for 3 seconds and then back to normal working mode.
  2. UP:Press this button once, the target temperature will increase by 1C or 1F (depends on which display mode is active now). When this button is pressed and hold, the target temperature will increase automatically fast.
  3. DOWN:Press this button once, the target temperature will decrease by 1C or 1F (depends on which display mode is active now). When this button is pressed and hold, the target temperature will decrease automatically fast.

ALARM AND PROTECTION

 

When the probe is with short-cut, the controller will stop the output and lights up the screen to alarm. A built in fuse is located in the controller, it will melt and stop the output when power loading is more than rated. The fuse will need to be changed when this happens.